Garage Door Torsion Springs operate on the basic principle of tension. Therefore extreme care is necessary when trying to replace the Torsion Springs. There is a metal shaft with torsion springs, just above the garage door containing a metal plate and two cables on either side of the door. These Torsion Springs get twisted while closing and provide the subsequent energy need to open the garage door.
Steps For Replacing The Torsion Springs In A Garage Door
Wear protective eye gear to shield the eyes from injury during the process as torsion springs can cause damage if unhooked when in tension.
Make sure to disconnect the power supply before attempting to start any repairs.
Make sure that the new Torsion Springs are of the same size and specification as the old ones. Using a torsion spring of different length could prove dangerous.
Unwind the old torsion springs and remove. Also remove the bolts that secure the springs to the shaft.
Put in the new springs in place of the old ones. Replace the whole thing as it was earlier.
Wind the newly replaced Torsion Springs.
Check the door balance and level to make sure that the replacement process was successful.
Some precautions which need to taken while changing the Torsion Springs of a garage door are:
All the tools and items required for this replacement process should be gathered at one place to avoid any confusion.
The tension in the torsion springs should be released entirely before unhooking it. Else it could cause serious damage.
Pets and kids should be kept away during this process to prevent any harm to either.
Refrain from touching the cable drum.
The brackets should not be touched especially when the springs are wound.
Avoid using a screwdriver for unwinding or winding the screw.
The new torsion springs should be checked to make sure they have enough windings.
Though replacing a Torsion Spring is an easy task if the proper procedure is followed, it is always better to call for professional help in case you are unsure. So Buy Torsion Springs only from manufacturers who can deliver good quality springs with excellent efficiency and durability.
This entry was posted on May, 17, 2012 at 16 : 32 pm and is filed under Torsion Springs. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response from your own site.